RS parts Prochargers, heads, tans.......

[Jim Coger]

Ford Mustang Fuel Injected 89-93 302 Used for Sale parts List

Two Prochargers, Two Proshifted TKO’s, Two sets of Trick Flow Heads and Lots more…….





Procharger P1sc-2 self contained non intercooler supercharger street tuner kit includes: Head unit(fresh from Procharger including a high speed balancing.), small bypass valve, crank pulley, blower pulley, fox-body supercharger bracket, tensioner, hardware and new 8 rib belt.***$2,000.



Procharger P1sc-2 RACE kit setup to use the F1R bracket and tensioner using a trick alternator bracket(included.) Kit includes The P1sc-2 head unit, the better Renegade bracket, over sized idler pulley, and mechanical tensioner assembly, a used 8 rib belt, custom accessory under drive crank pulley, trick alternator bracket, 4.13 blower pulley, and all the mounting hardware. I may be able to provide some piping inlet and outlet side that routes the boost to a stock location but draws air from above the intake/cowl area(The piping will not fit stock hood though!)***$2,300



TEA prepped/Lapointe Modified Trick Flow “NMRA Real Street” heads, these heads have 160psi springs(AFM) and hollow stem Tulip Exhaust valves . These heads have never been damaged or welded. ***$1,500



Kuntz prepped/Lapointe Freshened Trick Flow “NMRA Real Street” heads, these heads were originally heads from Brian Meyer’s/Anderson’s championship RS car(the best of the best in my opinion). I had the springs replaced (250lb seat pressure) and they were freshened up and used in the 2009 racing season. One head has been burnt in between 2 cylinders and has been professionally repaired. ***$1750


Ford Motorsport Aluminum Driveshaft with large yoke***$160

Trick Flow Street Intake includes Upper Plenum and lower intake as well as the hardware and a new gasket to mount the plenum to the lower intake.***$340




Reichard Racing 4.25” Ultra Grip Pulley for Procharger P1SC and D1SC in fox body.***$110



Accufab 70mm Race Throttle Body, it is a taper style housing to increase flow.***$180



Holley 80mm race TB with v band clamp flange welded on.***$160




Pro-M 80mm Mass air flow sensor Large 4” inlet housing calibrated for supercharged 75# inj.***$225



Holley 75 lb injectors low impedance. Summit gets over $700 new. Mine are used.***$400



Anderson race air filter with 3 stud mounting for Pro M. ***$30



K and N air filter with 3 stud mounting for Pro M ***$30


Bassani 2.5” X Pipe.***$190


All the parts are used and I have Pics of all the parts except the fixed heads, I have not picked them up from the engine shop yet.--Jim

cogiej@hotmail.com